A very strong cleaner, which can be used to soften up / remove baked on drying oils and Hard coke asphaltic deposition etc. It is low toxic product with an exceptional solvency power on soil & oily matter . It is minimizes the extreme hazards to personnel in handling materials.
Apply this to loosen frozen bolts, fittings and nuts. Cuts red or white lead, rust, grease, tar, carbon and graphite with special ingredients to help prevent further corrosion. Safe on basic metals. Works well with countersunk bolts also.
USING-PROCEDURE :-
The most economical method of using RXSOL PENETROSOL is by direct injection followed by recirculation washing, using tank cleaning machines.
Spraying Method :-
Using PENETROSOSL as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), and warm water 60oC for at least 3 hours
**Make sure to take all safety precautions are followed when handling / spraying PENETROSOSL **
Injection Method – not applicable.
Re-circulation Method :–
If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.
-
Use a strainer at the pump stack when circulating any solution.
SURFACE Lining – Stainless / Epoxy / Phenolic
Apply to surface and allow to soak and penetrate for 5 minutes. Attempt to open. If resistance to opening persists reapply penetrating oil and allow to soak.
Technical Information
| Appearance: Clear Liquid | Solubility: Insoluble | |
| Solids: 100% | Odor: Solvent | |
| Density: 7.6 Lbs./Gal. | pH Level: NA | |
| Stability: Good |
Flash Point: 250oF |
Characteristics :-
- Removes grease, oil, carbon deposits, soil and grime.
- Keeps loosened deposits in suspension preventing re-deposition.
- Low toxic., Non-flammable.
- Free from hydrocarbon solvents.
- Effective and economical in use , Water-based cleaner.
- RXSOL PENETROSOSL has numerous cleaning applications including removal of greases, waxes, oil, sludge, soot, carbon deposits and general dirt and grime.
- Non-corrosive to ferrous metals. Suitable for all tank-coatings.
- Can be used for gas and hydrocarbon freeing of tanks.
- Can be used for deodorizing
- Contains wetting agents.
| Product Name | RXSOL-16-1020-025 |
| Product Type | Penetrosol |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
| Phone | +91 22 65113333 / 5555 / 9999 / 27611360 |
| Fax | +91 22 2781 1318 |
| mail@rxmarine.com | |
| Website | www.rxmarine.com |
| Chemical Name | Concentration | CAS Number | EC Number | R Phrases* | Symbols |
| Naphtha (petroleum), hydrosulfurized heavy | 60-100 | 64742-82-1 | 265-185-4 | 65, 66 | Xn |
|
Hydrotreated heavy naphthenic destillate |
10-30 | 64742-52-5 | 265-155-0 | ||
| Methyl salicylate | 1-5 | 119-36-8 | 204-317-7 | 22, 36/37/38 | Xn |
| 2-(2-Butoksyethoxy)ethanol | 1-5 | 112-34-5 | 203-961-6 | R36 | Xi |
*See Section 16
|
Odour: Characteristic odour, Smells of hydrocarbon |
| Contact with skin | Wash affected area with plenty of water |
| Contaminated clothing should be laundered before reuse | |
| Contact with eyes | If substance has got into eyes, immediately wash out with plenty of water for several minutes |
| When in doubt or symptoms persist, seek medical attention | |
| Ingestion | |
| - | Do not induce vomiting because of risk of aspiration into the lungs. If aspiration is suspected obtain immediate medical attention |
| - | Give 200-300mls (half pint) water to drink |
| - | Obtain immediate medical attention |
| inhalation | |
| Remove patient to fresh air | |
| When in doubt or symptoms persist, seek medical attention | |
| General | |
| In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible) (S45) |
| - | Auto-ignition point 230 deg C at 760 mm Hg |
| - | Flash point >63 deg C (CC) |
| - | Decomposition products may include carbon oxides |
| Personal Precautions | |
| Wear protective clothing as per section 8 | |
| Environmental Precautions | |
| Do not allow to enter public sewers and watercourses | |
| Clean Up Actions | |
| Soak up with inert absorbent | |
| Wash spill site with water and detergent |
| Handling | |
| The usual precautions for handling chemicals should be observed | |
| Storage | |
| Keep away from open flames, hot surfaces and sources of ignition. |
| Exposure Limits | |
| Naphtha (petroleum),hydrosulfurized heavy | |
| TLV (TWA) 275 mg/m3 (Naphtha, low boiling, hydrogen treated) | |
| Exposure controls | |
| No special precautions are required for this product | |
| Occupational exposure controls | |
|
Respiratory protection may be required under exceptional circumstances when excessive air contamination exists |
|
| Wear plastic or rubber gloves | |
| Odour: | Characteristic odour, Smells of hydrocarbon |
| Appearance | Liquid, colourless to yellow, insoluble in water |
| pH - | not applicable |
| Boiling point | 180 °C to 270 °C at 760 mm /Hg |
| Vapour density |
(air = 1) >1 |
| Insoluble in water | |
| Specific gravity | (water=1) 0.81 |
| Flash point | >63 deg C (CC) |
| Auto-ignition point | 230 deg C at 760 mm Hg |
| Upper explosive limit | 8 % (in air) |
| Lower explosive limit | 0.6 % (in air) |
| - | This article is considered stable under normal conditions |
| - | Keep away from naked flames, incandescent or hot surfaces |
| - | See Section 5 |
| Toxicological information | ||
| - |
No experimental data available Inhalation |
|
| Inhalation | ||
| - |
Inhalation of solvent vapours may give rise to nausea, headaches and dizziness |
|
| Contact with skin | ||
| Prolonged skin contact will result in defatting of the skin, leading to irritation, and in some cases, dermatitis | ||
| Contact with eyes | ||
| Causes irritation | ||
| Ingestion | ||
| Not regarded as a potential route of exposure. | ||
| Aspiration hazard | ||
| The ingestion of significant quantities may cause damage to lungs | ||
| Carcinogenicity | ||
| No evidence of carcinogenic effects |
| Ecotoxicity | |
| - |
This product does not contain ingredients which are classified in the EU as dangerous for the environment. |
| Mobility | |
| Persistence and Biodegradability | |
| - | Most components in this product are not readily biodegradable. |
| Bioaccumulation Potential | |
| - | Hydrocarbon solvents have the potential to bioaccumilate. |
| Other Adverse Effects | |
| - |
No environmental problems are expected when the product is used / handled correctly. In its intended use, the product will not be released into the environment. |
| Classification | |
| - | EU Waste class: 07.01 |
| Disposal considerations | |
| - | Do not discharge into drains or the environment, dispose to an authorised waste collection point |
| - | Disposal should be in accordance with local, state or national legislation |
Not classified as hazardous for transport
| Risk Phrases | |
| - | Harmful: may cause lung damage if swallowed (R65) |
| - | Repeated exposure may cause skin dryness or cracking (R66) |
| Safety Phrases | |
| - | If swallowed, do not induce vomiting: seek medical advice immediately and show this container or label (S62) |
| - | Avoid contact with skin (S2 |
| - | Do not breathe gas (S23) |
| - | Do not breathe vapour/fumes (S23) |
| - | Do not breathe spray/mists (S23) |
|
Text of R and S phrase codes used in this safety data sheet:- R22: Harmful if swallowed; R36: Irritating to eyes; R36/37/38: Irritating to eyes, respiratory system and skin; R65: Harmful: may cause lung damage if swallowed; R66: Repeated exposure may cause skin dryness or cracking.
The information provided about the product on this Safety Data Sheet has been compiled from knowledge of the individual constituents DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable. |