Carbon Remover

This powerful action is based on a two –Layer mechanism. The top-layer prevents the evaporation of the volatile components in the button-layer. The button –layer removes the deposited substances. This way, the deposits are bind and trapped result
Category

RXSOL-16-1003-020 is a highly concentrated for extremely high solvency and penetrating capabilities to remove carbonaceous Wetting Emulsifying Agent. Specifically formulated for removal of completely carbon, grease, oil, varnishes and other heavy deposits from diesel engine.


This powerful action is based on a two –Layer mechanism. The top-layer prevents the evaporation of the volatile components in the button-layer. The button –layer removes the deposited substances. This way, the deposits are bind and trapped resulting to complete and safe removal.

CARBON cleaner is very active which eliminates the need for Scrubbing or Brushing  which can cause mechanical damages to discs and result in poor performance

Application

For removal of carbon deposits it must be used concentrated ,contained in a steel immersion bath.

SAFETY AND HANDLING:- Completely  Avoid contact with eyes as irritation may occur. Do not take internally. In case of contact with eyes, flush eyes immediately and cupiously with clean running  water for 15- minutes and seek medical attention.
 

Dose

Depending upon the deposition either concentrated or diluted .If used diluted use 1 part concentrate to 2-10 parts of water to yield a very effective end product. The components and machine parts are then dipped into the solvent / solution for 30 min. to 1 hr. Heavy deposition may need 12-24 hours , parts must be taken out from the bath and washed thoroughly with a high- pressure water supply jet system.

concentrated RXSOL-16-1003-210 is most effective product in its category due to its quick and complete action.  can be applied for cleaning of highly soiled components. blocks, gear boxes, pistons, rings, valves, atomizers, pipes, burners, coolers, cylinder heads, injectors, tubes, oil filters , old paint and lacquers ) 

 

Technical specifications
Product Properties
Odour ......................................Unpleasant odour
Appearance .............................Liquid, brown, dispersible in water
pH ...........................................10-11 (5% in 50/50 H2O-IPA mix)
Boiling point ............................100 °C at 760 mm /Hg
Vapour pressure ......................Not known
Vapour density .......................(air = 1) & 01
Freezing point .........................<0 °C at 760 mm/Hg
Specific gravity ......................(water=1) 1.02
Flash point .............................70 deg C (CC)
Note

Non- evaporation prevents loss of chemical.

CHARACTERISTICS :-

  • Unique chemical formulation with corroision inhibitor
  • Non- toxic
  • Extends time between cleans.
  • Effective removal of STICKER/CARBON DEPOSITS , completely heavy carbon, grease oil, varnish and other deposits as well as old paints, resins and lacquer coatings
  • Can be applied by all normal methods.
  • Formulated to be very cost effective.
  • Does not contain chlorinated hydrocarbons.
  • Can be used on all metals & most painted surfaces.
  • 100% Active.
  • Dries Completely.
  • Does not require special feeding equipment for safe application.
  • Reduce downtime and maintenance costs.
Packing sizes
5Ltr, 25 ltr., 50 ltr. standard packing of CARBON REMOVER available in ready stock. RXSOL CARBON REMOVER is an advanced new generation product helps to remove carbon and clean machinery parts without hard surface scrubbing. As mechanical cleaning scrubbing damage the surface finishes, while carbon cleaner chemically cleans hard deposition.
MSDS

Product Name

RXSOL-16-1003-210

Product Type

CARBON REMOVER-III

Company Details:

RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA

Phone +91 22 65113333 / 5555 / 9999 / 27611360
Fax +91 22 2781 1318 :::AOH :0091 9821214367
Email mail@rxmarine.com

Chemica Name

Concentration

CAS Number

EC Number

R Phrases*

Symbols

1,2-Dichlorobenzene

30-60 

95-50-1 

202-425-9 

22, 36/37/38, 50/53 

Xn, N 

Emulsified Xylenol 

10-30

1300-71-6 

 215-089-3

24/25, 34, 51/53 

T, N 

Emulsifiable Liq of Aliphatic & Aromatic, unspecified 

10-30 

64742-94-5 

265-198-5 

 65, 66, 51, 53

Xn, N 

Naphtha(petroleum)hydrosulfurizedheavy

10-30 

64742-82-1 

265-185-4 

65, 66 

 Xn

*See Section 16

toxic                           danger for environment.

                      Toxic                   Danger For Environment.

Odour

Unpleasant odour, Strong smell of phenol.

Appearance

Liquid, brown, dispersible in water.

Contact with eyes

Can cause damage to the eyes.

Contact with skin

Causes burns (R34), Toxic in contact with skin and if swallowed (R24/25).

Inhalation

May cause severe irritation, May cause dizziness, confusion, headache or stupor, In cases of severe exposure, anaesthesia may develop.

Ingestion

Toxic if swallowed (R25).

 

Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment (R50/53.

Dangerous for the Environment

Remove contaminated clothing immediately and drench affected skin with plenty of water. Then  wash with soap and water When in doubt or symptoms persist, seek medical attention.Contaminated clothing should be laundered before reuse.

Contact with eyes

If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes Irrigate eyes thoroughly whilst lifting eyelids.Seek immediate medical attention Continue flushing with water until medical help arrives.

Ingestion

Never make an unconscious person vomit or drink fluids Give plenty of water to drink Do not induce vomiting Seek immediate medical attention.

Inhalation

Remove patient to fresh air.Keep warm and at rest, in a half upright position. Loosen clothing When in doubt or symptoms persist, seek medical attention.

General

In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible)  (S45).

-   Flash point >70 deg C (CC)
-   Decomposition products may include phosgene, Decomposition products may include carbon oxides
-   In case of fire use water spray or fog, alcohol resistant foam, dry chemical or carbon dioxide (S43)
-   Substance evolves toxic fumes, wear self-contained breathing apparatus
-   Prevent run off water from entering drains if possible
-   Use water spray or fog to knock down and absorb corrosive fumes
-   Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback

Personal Precautions
 

Wear protective clothing as per section 8. Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback.

Environmental Precautions

Do not allow to enter public sewers and water courses.

Immediate Actions

Use appropriate containment to avoid environmental contamination (S57).

Clean Up Actions

Absorb spillage in inert material and shovel up. Ventilate the area and wash spill site after material pick-up is complete .

Special Precautions

Wear protective clothing as per section 8 Avoid release to the environment. Refer to special instructions/Safety data sheets (S61) Vapours are heavier than air and may travel considerable distances to a source of ignition and flashback.

Handling

See Section 8 Eye wash bottles should be available Avoid contact with skin and eyes (S24/25)

Storage

Keep only in the original container in a cool, well ventilated place (S3/9/49)

Exposure Limits

TLV (TWA) 20 ppm, 122 mg/m3 (1,2-Dichlorobenzene) 

Exposure controls

The undiluted product must not be used in a confined space without good ventilation

Occupational exposure controls
 

Wear approved respirator if exposure likely to exceed MEL/OES Wear goggles giving complete eye protection  Wear suitable protective clothing, including eye/face protection and gloves (neoprene or nitrile are recommended)

respirator                                          

Respirator              Gloves                     Suit              No_Smoking

Odour

Unpleasant odour, Strong smell of phenol

Appearance

Liquid, brown, dispersible in water

pH

10-11 (5% in 50/50 H2O-IPA mix)

Boiling point

> 100 °C at 760 mm /Hg

Vapour pressure

not known

Vapour density

(air = 1) >01

Freezing point

0 °C at 760 mm/Hg

Insoluble in water

Specific gravity

(water=1) 1.02

Flash point

>70 deg C (CC)

-   This article is considered stable under normal conditions, May cause rubber to swell
-   Avoid overheating
-   Incompatible with strong oxidizing substances, Contact with alkaline earth metals may form explosive
    gases, Contact with alkali metals may form explosive gases
-   See Section 5

Toxicological information

No experimental data available Inhalation.Vapours or aerosols may cause irritation of eyes, nose and respiratory tract.

Contact with skin

In cases of severe exposure, redness and irritation may develop.

Contact with eyes

Causes irritation.

Ingestion

May cause gastro-intestinal disturbances.

Carcinogenicity

No evidence of carcinogenic effects.

Ecotoxicity

This product does not contain ingredients which are classified in the EU as  dangerous for the environment.

Mobility

Completely soluble in water.

Persistence and Biodegradability

Its main ingredients will either dissolve rapidly and dissociate in water or are readily/inherently biodegradable.

Bioaccumulation Potential

Bioaccumulation of the components in this product is insignificant. Other Adverse Effects. No environmental problems are expected when the product is used / handled correctly.

Classification

This material and/or its container must be disposed of as hazardous waste  EU Waste class   Disposal considerations Do not discharge into drains or the environment, dispose to an authorised waste collection point Disposal should be in accordance with local, state or national legislation

Proper Shipping Name:
UN        
  Proper Shipping Name: Toxicliquid organic, n.o.s  (Xylenol, 1,2-dichlorobenzene)  
  UN NO.

2810

   
  Hazard Class 6.1 PackingGroup III

Road/Rail(ADR/RID)

  Proper Shipping Name

Toxicliquid, organic, n.o.s.

 (Xylenol, 1,2-dichlorobenzene)  
  ADR UN No.

2810

   
 

ADRHazardClass

6.1 Tremcard

61GT1-III

Sear (IMDG)
  Proper Shipping Name

Toxicliquid, organic, n.o.s.

 (Xylenol, 1,2-dichlorobenzene)  
  IMDG UN No.

2810

   
  IMDG Hazard Class 6.1 ICAO PackingGroup

III

  IMDG EmS F-A, S-A IMDG subrisk:

N/A

  IMDG Labels

6.1+Mar

Pollutant

 

 

IMDG Flashpoint

 >70°C

   

Air(ICAO/IATA)

  ProperShippingName

Toxicliquid, organic, n.o.s.

 (Xylenol, 1,2-dichlorobenzene)  
  ICAO UnNo

2810

   
  ICAO HazardClass 6.1 ICAO PackingGroup

III

  ICAO subrisk N/A ICAO Labels  6.1
  ICAO Flashpoint

>70°C

   

DOT/ CFR(USDepartment ofTransportation

  DOTProperShippingName

Toxicliquid, organic, n.o.s.

 (Xylenol, 1,2-dichlorobenzene)  
 

HazardousMaterial

Xylenol,  1,2-dichlorobenzene  
  HazardClass 6.1 IdentificationNumber UN2810
 

Product RQ (lbs)

100 DOTsubrisk:

MarinePollutant

 

DOTLabels

6.1+Mar

 Pollutant  
  DOTFlashpoint

>70°C

   

Risk Phrases

Irritating to eyes (R36)

Safety Phrases Irritant

In case of contact with eyes, rinse immediately with plenty of water and seek medical advice (S26) Wear suitable gloves and eye/face protection (S37/39)

Text of R and S phrase codes used in this safety data sheet:- R34: Causes burns; R36: Irritating to eyes; R37: Irritating to respiratory system; R41: Risk of serious damage to eyes. The information provided about the product on this Safety Data Sheet has been compiled from knowledge of the individual constituents The data given here is based on current knowledge and experience. This Safety Data Sheet describes the product in terms of safety requirements and does not signify any warranty with regard to the product's properties The data given here only applies when product used for proper application(s). The product is not sold as suitable for other applications - usage in such may cause risks not mentioned in this sheet. Do not use for other application(s) without seeking advice from manufacturer This Safety Data Sheet is provided in compliance with The Dangerous Substances Directive (67/548/EEC) This Safety Data Sheet is provided in compliance with The Dangerous Preparations Directive (88/379/EEC) This Safety Data Sheet is provided in compliance with The Safety Data Sheets Directive (2001/58EC) Composition information in accordance with Regulation (EC) No 648/2004 of the European Parliament and of the Council of 31 March 2004 on detergents: Nonionic surfactants 5-15 % Amphoteric surfactants 5 %

Need a quote for this product?

Tell us the grade, packing and quantity you need — we ship across India and to major ports.

Request a quote office@mumbaichemical.com