Active Chem COIL Cleaner RXSOL Manufacturer

MUMBAI CHEMICAL is leading one Largest Supplier, Manufacturer and Exporter of Active Chem COIL Cleaner RXSOL in Maharashtra, Mumbai, Thane, Navi Mumbai, Panvel, Raigad, Chiplun, Ratnagiri, Kudal, Kolhapur, Sangli, Karad, Satara, Pune, Nashik, Sambhaji Nagar, Ahmadnagar, Palghar, Tarapur( Boiser) , Dhule, Nandurbar, Jalgaon, Kurkumbh (Daund), Osmanabad, Latur, Nanded , Buldhana, Amaravati, Vashim, Akola, Nagpur, Vardha, Yavatmal, Chandrapur, Bhandara, Gadchiroli.

Product Information:
Active Chem COIL Cleaner RXSOL: RXSOL-16-1697-003
RXSOL-16-1697-003 is a concentrated outdoor condenser coil cleaner and brightener. It effectively foams away stubborn,’baked on’ lint, smoke film, insects, feathers, grass, leaves and other deposits from air cooled condenser coils. The expanding foam pushes contamination out of the coil and is easily rinsed away with water. In addition to removing contaminants, the RXSOL COIL CLEANER formula effectively restores efficiency and reduces operating cost by removing hidden oxidation from the coil surfaces.

Product Application:
Using Procedure:
USES:
Deep cleaning of outdoor condenser coils to restore efficiency and increase performance of the system.

DILUTION RATIOS:
Because RXSOL-16-1697-003 is highly concentrated, it must be diluted prior to use. Dilution also improves penetration into the coil and increases product performance. Actual dilution ratios will vary according to the application. The following is intended as a general guideline:
Up to 8-10 parts water to 1 part RXSOL Active Chem  for light cleaning and brightening, when expanding foam is not required.
3-5 parts water to 1 part RXSOL Active Chem  for foaming action on difficult cleaning tasks.
1-2 parts water to 1 part RXSOL Active Chem  for use as a high foaming, aluminum finned, air cooled condenser coil cleaner. Use the minimum concentration required to accomplish your task.

Note: Do not use RXSOL-16-1697-003 at concentrations greater than 1:1 (less than 1 part water to 1 part RXSOL-16-1697-003 . Rinse the treated surfaces as well as the surrounding area thoroughly after use.

APPLICATION METHODS:
Low pressure, acid resistant tank sprayers are recommended.
Regardless of application method, avoid inhalation of mist or contact of liquid or mist with skin.

SUGGESTED INSTRUCTIONS FOR USE:
When handling RXSOL-16-1697-003 or any other strong chemical, be sure to wear chemical impervious gloves, apron and splash goggles.

Determine required dilution ratio for the specific application. It is recommended to start with a dilution ratio of 10:1 and increase concentration until the desired results are achieved.
As with mixing all acids, place the desired amount of water into the tank and then add RXSOL-16-1697-003
Turn off fans and allow hot coils to cool before applying.
Using plain water, wet both the condenser coil as well as the area surrounding the equipment. Wetting the coil with water aids in product penetration and performance.
Apply the properly diluted product to the coil surface. Whenever possible, apply a solution from the outlet side of the coil. Allow the product to remain on the surface, normally 5-10 minutes. Do not allow the product to dry on the coil. Note: In extreme cases, application may have to be repeated to achieve desired results.
If foaming does not occur, check for extreme grease buildup which will slow the cleaning process. Foaming may not occur if the coil is coated or painted.
Rinse coils, tools and surrounding area thoroughly after completing the coil cleaning process

Product Note:
CAUTIONARY NOTES:
This product is for professional use only.At full strength:
It will cause burns to skin and eyes.
Ingestion will cause severe and potentially fatal gastric distress.
Vapors are harmful and may cause respiratory tract irritation.
May be harmful to plants.
Refer to MSD sheet for further information. MSD sheets are available at your local wholesaler

Product Technical Specification:
CHARACTERISTICS:
Heavy foaming action.
Solvent-Acid blend (pH: <2.0).
Removes oxidation – brightens aluminum.
Bright pink liquid.

Available Packing Size: 5, 10, 20, 25 Ltr.

MUMBAI CHEMICAL offers highest quality products in Tank cleaning, Drilling Fluid Chemicals, Hold Solution, Agriculture, Lab Chemicals, Raw Chemicals, Sewage Chemicals, Detergent, Degreaser & Floor care chemical. Our in house lab and QC department is strong in equipment, knowledge and system to meet the international standards. We produce a superior range of Active Chem COIL Cleaner RXSOL with advanced manufacturing technology and using superior quality raw materials. We assure quality and ensure that only the best is catered to the customers. Our basic motto of the company is to give a better product to the customer at the lowest rate. We are keeping a ready stock of Active Chem COIL Cleaner RXSOL for more information, any support and price, Feel free to contact us through our Email id mumbaichems @ gmail.com

We are presently operative in all over India and you can buy our products from various location Like Andhra Pradesh, Tamil nadu, Gujarat , West Bengal  and also all seaports of India. We do have many satisfied customers in this Industries because of our QUALITY, PRICING & SERVICE. Our Company is also a Major Exporter & Mfg of Active Chem COIL Cleaner RXSOL in UAE, Oman , Vietnam, Europe, Africa, Bahrain, Qatar, Africa & many more countries.

Supply Locations :
Maharashtra , Mumbai, Thane, Navi Mumbai, Panvel, Raigad, Chiplun, Ratnagiri, Kudal, Kolhapur, Sangli, Karad, Satara, Pune, Nashik, Sambhaji Nagar, Ahmadnagar, Palghar, Tarapur( Boiser) , Dhule, Nandurbar, Jalgaon, Kurkumbh (Daund), Osmanabad, Latur, Nanded , Buldhana, Amaravati, Vashim, Akola, Nagpur, Vardha, Yavatmal, Chandrapur, Bhandara, Gadchiroli, All over Maharashtra.